NX5 drafting variables

<W@$SH_SHEET_NUMBER> – Sheet number of the current sheet

<W@$SH_NUMBER_OF_SHEETS> – Number of sheets in the current part

<W@$SH_SHEET_SCALE_NUMERATOR> – Numerator of the sheet scale

<W@$SH_SHEET_SCALE_DENOMINATOR> – Denominator of the sheet scale

<W@$SH_SHEET_SIZE> – Size of the current sheet

<W@$SH_SHEET_UNITS> – Units of the current sheet

<W@$SH_SHEET_PROJECTION_ANGLE> – Projection angle symbol of the current sheet

<W@$SH_MASTER_PART_NAME> – Master Model drawing sheet part name

<W@$SH_PART_NAME> – Sheet part name

This website uses IntenseDebate comments, but they are not currently loaded because either your browser doesn't support JavaScript, or they didn't load fast enough.

5 Comments to “NX5 drafting variables”

  1. Mike 19 August 2009 at 3:23 pm #

    <W@$SH_SHEET_NUMBER> doesnt seem to work for me it leaves the field blank rather than giving me a sheet number.
    The <W@$SH_NUMBER_OF_SHEETS> works well so maybe there is a name change that doesn't allow the first on to give me a sht number..

    Anyone have a solution?

    Reply
  2. tolsma 19 August 2009 at 9:20 pm #

    This should work with NX5, what version are you using?

    Reply
  3. Mike 20 August 2009 at 6:54 pm #

    NX5 5.0.3.2

    Reply
  4. Mike 31 August 2009 at 6:12 pm #

    Anyone??

    Reply
  5. Guest 30 October 2009 at 12:44 pm #

    Does anyone know the syntax to show in a drawing annotation a sheet model property (like any user defined property on the master model)?

    Reply

Leave a Reply